How to install a belt light?

Prepare tools and materials‌: Make sure you have the right tools, such as screwdrivers, wire cutters, etc., as well as the required belt light fixtures, switches, and batteries.

‌Remove the old light fixture‌: If you need to replace the old light fixture, first remove the old light fixture from the belt or bracket using tools such as screwdrivers.

‌Install the new light fixture‌: Place the new light fixture on the belt or bracket and make sure it is stable. Use wire cutters to trim the wires to the appropriate length and connect the switch and battery.

‌Fix the switch and battery‌: Use screws or other fixings to fix the switch and battery in place to ensure that they will not loosen.

‌Test the light fixture‌: After installation, turn on the switch to test whether the belt light is working properly. If any problems are found, adjust and repair them in time.

‌Precautions‌:

‌Safety first‌: During the installation process, pay attention to electrical safety and avoid the risk of electric shock.

‌Connect the wires correctly‌: Make sure that the wires are connected correctly to avoid short circuits or open circuits.

‌Adjust the angle‌: Adjust the angle of the light fixture as needed to ensure that the light is evenly distributed.

‌Regular inspection‌: After installation, regularly check the working status of the belt light to ensure its long-term stable operation.

Through the above steps and precautions, you can successfully install the belt light and ensure that it works safely and effectively.